Plug in. Press flash.
Get a verdict.
This page talks to the board over USB. Nothing to install, no terminal, no ESP-IDF. It writes the firmware we approved, then runs the same acceptance test an engineer would run by hand, and tells you pass or fail.
The run
- 01 Connect Pick the board's COM port. Only adapter types we use show up.
- 02 Flash Writes the merged image, then checks the bytes landed.
- 03 Test Drives the firmware console through the acceptance checks.
- 04 Verdict A straight answer, or the exact step that failed.
Plug the board into USB, then press Connect. Windows should already show it as a COM port.